GC G-Bond Dental Adhesive Kit

– Kit contains:
– 1 X 5ml bottle
– 50 X Micro-tips
– 1 X Micro-tip Handle
– 1 X Dispensing dish
– The GC G-Bond is a new, revolutionary 7th Generation (single component) adhesive that takes the guesswork out of bonding
– The unique combination of Phosphoric Acid Ester Monomer and 4-MET Adhesive Technology creates superior etch and adhesion to enamel, in addition to providing a chemical and mechanical seal to dentin (referred to as the Nano Interaction Zone)
– Mild etching of enamel and dentine allows the tubules to stay closed providing a very low risk of post-operative sensitivity
– Presence of two different functional monomers creates chemical adhesion to the tooth structure
– Simultaneous demineralization, and monomer infiltration results in a better seal resulting in less nano-leakage
– One component system with a simplified application technique saves time – a 30-second procedure
– Ease of use with low sensitivity to dentine moisture control ensuring reliable adhesion
– The GC G-Bond Dental Adhesive is HEMA free to avoid the risk of allergic reactions
– 5% filler seals tubules leads to fewer voids between the thin adhesive layer and the dentin, which minimizes microleakage and prevents microbial invasion
– It virtually eliminates post-op sensitivity because dentin tubules are never exposed (due to 5% filler)
– The dental adhesive completely coats all bonding surfaces even in an extremely shallow cavity; fewer voids
– High surface tension makes it easier to apply and remain on all bonding surfaces
– Available in bottle and in-unit dose
– Precautions:
– G-BOND is flammable. Do not use near naked flame. Keep away from sources of ignition. Do not store large quantities in one area. Keep away from direct sunlight.
– G-BOND is volatile. Use in a well ventilated place
– In case of contact with eyes, flush immediately with water and seek medical attention
– In case of contact with oral tissue or skin, immediately remove with a sponge or cotton pellet. After the restorative treatment is finished, rinse thoroughly with water.
– If the tissue contacted by the material turns white or forms a blister, advise the patient to leave the affected area undisturbed, until the mark disappears, usually in 1-2 weeks. To avoid contact, it is recommended to apply cocoa butter to the area where rubber dam cannot cover.
– Avoid inhalation or digestion of material
– When spilt on the table or floor, immediately wipe off with a dry cloth
– Do not mix with other products
– Dispose of all waste according to local regulations